Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Source-Based Routing in PIX

Hi There,

I'm trying to lookup a way to do source-based routing in PIX to achieve the same functionality of the "route-map" command in Cisco routers; is there an equivalent command for it in PIX version 7.x? I recall that this wasn't available in previous versions and I couldn't find this out in version 7.x, too but I wanted to double confirm this with you.

Thanking in advance.

Regards,

Haitham

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Source-Based Routing in PIX

Haitham,

Your understanding is correct, Policy Based Routing is not supported on the Pix Firewall.

Also, dont get confused when you see the "route-map" command option in Pix 6.3 and higher. This command is applicable only when redistributing routes into OSPF.

Pix 6.3 Command Reference:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#wp1017196

Pix 7.2 Command Reference

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/qr_711.htm#wp1648744

Let me know if it helps.

Regards,

Arul

1 REPLY
Cisco Employee

Re: Source-Based Routing in PIX

Haitham,

Your understanding is correct, Policy Based Routing is not supported on the Pix Firewall.

Also, dont get confused when you see the "route-map" command option in Pix 6.3 and higher. This command is applicable only when redistributing routes into OSPF.

Pix 6.3 Command Reference:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#wp1017196

Pix 7.2 Command Reference

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/qr_711.htm#wp1648744

Let me know if it helps.

Regards,

Arul

197
Views
0
Helpful
1
Replies
CreatePlease to create content