I have an span port configured on 1 port of the switch to monitor all the others ports.The device that's connected to the span port needs to be accesible. I need to connect to this server by the ip address that it has configured.
Can i access this device with the Span port that is configured simultaneously ?
The 2950 supports only a single SPAN session and it can be for all ports on the device excluding the destination port. So I guess you would not be able to span the server connected on the destination port. Take a look at this document for the concepts.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...