Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SPLIT Tunnel - Config

Hi,

I have 3640 Router currently used for Site to Site VPN with HeadOffice..

I need to configure SPLIT-Tunneling on 3640 router....

Plz advice commands....

1 REPLY
Silver

Re: SPLIT Tunnel - Config

For split tunnel you need to configure an ACL and mention the IP address of the remote network to which the traffic is to be encrypted. Then apply this ACL using crypto map's match address statement. Following links may help you

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a008073b06b.shtml#config

http://www.cisco.com/en/US/products/hw/routers/ps274/products_configuration_example09186a0080819289.shtml#config

123
Views
0
Helpful
1
Replies
CreatePlease to create content