Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spoke to Spoke thru 3005 not supporting tunnel default

After implementing spoke to spoke communications for my 3005 system working with TAC I was instructed to set tunnel default gateway to 0.0.0.0. I later discovered this has broken my VPN Clients Internet access (anything with-out a route). I'm using ver4.1 on my 3005. All equipment is Cisco and configured with using TAC config guides. Does anyone have this working successfully?

1 REPLY
New Member

Re: Spoke to Spoke thru 3005 not supporting tunnel default

I believe that is how it is supposed to work

73
Views
0
Helpful
1
Replies
CreatePlease to create content