Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ssh fails from ciscoworks

I am trying to get our CiscoWorks to manage a PIX 520 firewall running ver 6.3.3. It seems to get SNMP information but getting and managing the configs has been a problem. When I look in the PIX log I see this message: INFO %PIX-6-315011: SSH session from 10.80.134.21 on interface inside for user "manage" disconnected by SSH server, reason: "packet CRC check failed" (0x02).

The session gets set up but then it gets dropped.

I can't find any information on pix message 315011. I can ssh into the pix using putty just fine. Can Ciscoworks even do this?

Thanks,

Steve

2 REPLIES
New Member

Re: ssh fails from ciscoworks

I found this:

http://www.cisco.com/en/US/customer/products/sw/secursw/ps2120/products_system_message_guide_chapter09186a0080089b20.html#91677

CRC check failed - The CRC value computed for a particular packet does not match the CRC value embedded in the packet; the packet is bad - No action required. If this message persists, call customer support.

Perhaps your ciscoworks box is creating bad packets ? Can you SSH from the same box, or sniff the traffic and capture the packets (look at the CRC's)?

Just some thoughts..

Silver

Re: ssh fails from ciscoworks

130
Views
0
Helpful
2
Replies
CreatePlease to create content