Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SSH on CISCO 828G

Hi

How does one Configure SSH on a cisco 828G router with IOS 12.3(6e)

thanks

7 REPLIES
Gold

Re: SSH on CISCO 828G

assuming you are referring to manage the router remotely via ssh.

below are the sample codes:

hostname router828g

ip domain-name yourcompany.com

crypto key generate rsa

1024

line vty 0 4

transport input telnet ssh

username cisco password cisco123

aaa new-model

in case an inbound acl is being applied, ssh to the router needs to be permitted as well.

New Member

Re: SSH on CISCO 828G

Hi Jackko

the error message it get

router828G(config)#hostname router828G

router828G(config)#ip domain-name company.com

router828G(config)#crypto k

router828G(config)#crypto key generate rsa

^

% Invalid input detected at '^' marker.

It seems as if Crypto is not a keyword in the IOS

these are the only commands under "c"

router828G(config)#c?

cdp class-map clock cns

config-register

thanks

Re: SSH on CISCO 828G

New Member

Re: SSH on CISCO 828G

Hi

the error message it get

router828G(config)#hostname router828G

router828G(config)#ip domain-name company.com

router828G(config)#crypto k

router828G(config)#crypto key generate rsa

^

% Invalid input detected at '^' marker.

It seems as if Crypto is not a keyword in the IOS

these are the only commands under "c"

router828G(config)#c?

cdp class-map clock cns

config-register

thanks

Re: SSH on CISCO 828G

Hi

You need to check whether your ios code does support crypto command in that ....

I would suggest to post out the exact filename which is there in the flash so that it can be checked out whether its a simple plain ios base or it has ipsec ingredients too in that so that it can suppor the crypto commands.

also do verify the links i have attached in my previous mails to note the prequisties for configuring ssh in ur box..

regds

New Member

Re: SSH on CISCO 828G

Hi

Lab828G#cd flash:?

flash:c828-y6-mz.123-6e.bin

thanks

Re: SSH on CISCO 828G

Hi

You need to have c828-k9osy6-mz.123-6e.bin which will serve the purpose here.

But to have the same loaded onto ur box u need to have 8MB Flash and 24MB DRAM.

if u have them both in ur box and if u have cco id with enough privileges u can download the file from this location..

http://www.cisco.com/cgi-bin/Software/Iosplanner/Planner-tool/iosresult.cgi?get_crypto=&data_from=&hardware_name=828&software_name=IP%2FFW%20PLUS%203DES&release_name=12.3.6e&majorRel=12.3&state=:HW:RL:SW&type=Limited%20Deployment

regds

154
Views
0
Helpful
7
Replies
CreatePlease to create content