09-14-2006 01:50 AM - edited 03-09-2019 04:11 PM
Hi,
I have enabled ssh ver 1 at my router and when I issue the command "sh ip ssh" the output obtained is:
SSH Enabled - version 1.5
Authentication timeout: 20 secs; Authentication retries: 5
I'm using 'putty' now to access router. Its asking for login as & password. My understanding is that password is the one that I have set on vty lines, isn't? what should I use in login as? If anyone can please help? Thanks.
Solved! Go to Solution.
09-14-2006 05:08 AM
Did you configure the following on your VTY lines: transport input ssh
You can also verify your config with the sample here: http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml
Hope this helps.
Steve
09-14-2006 05:08 AM
Did you configure the following on your VTY lines: transport input ssh
You can also verify your config with the sample here: http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml
Hope this helps.
Steve
09-14-2006 08:18 AM
Syed,
It really depends upon what kind of authentication is configured under line vty for Login.
If you have AAA configured, then you need to use the Username/Password on the AAA Server.
Is there anyway, you could post any AAA and line vty configuration. Make sure that remove all sensitive (passwords,etc) information before you post the configuration.
I hope it helps.
Regards,
Arul
09-15-2006 04:13 AM
Thanks a lot. It helped. I used "transport input ssh" & "login local" on my vty lines.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide