SSH..

[sqambera]

Hi,

I have enabled ssh ver 1 at my router and when I issue the command "sh ip ssh" the output obtained is:

SSH Enabled - version 1.5

Authentication timeout: 20 secs; Authentication retries: 5

I'm using 'putty' now to access router. Its asking for login as & password. My understanding is that password is the one that I have set on vty lines, isn't? what should I use in login as? If anyone can please help? Thanks.

[stomasko · Accepted solution]

Did you configure the following on your VTY lines: transport input ssh

You can also verify your config with the sample here: http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml

Hope this helps.

Steve

[ajagadee]

Syed,

It really depends upon what kind of authentication is configured under line vty for Login.

If you have AAA configured, then you need to use the Username/Password on the AAA Server.

Is there anyway, you could post any AAA and line vty configuration. Make sure that remove all sensitive (passwords,etc) information before you post the configuration.

I hope it helps.

Regards,

Arul

[sqambera]

Thanks a lot. It helped. I used "transport input ssh" & "login local" on my vty lines.