Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SSH..

Hi,

I have enabled ssh ver 1 at my router and when I issue the command "sh ip ssh" the output obtained is:

SSH Enabled - version 1.5

Authentication timeout: 20 secs; Authentication retries: 5

I'm using 'putty' now to access router. Its asking for login as & password. My understanding is that password is the one that I have set on vty lines, isn't? what should I use in login as? If anyone can please help? Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: SSH..

Did you configure the following on your VTY lines: transport input ssh

You can also verify your config with the sample here: http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml

Hope this helps.

Steve

3 REPLIES
Silver

Re: SSH..

Did you configure the following on your VTY lines: transport input ssh

You can also verify your config with the sample here: http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml

Hope this helps.

Steve

Cisco Employee

Re: SSH..

Syed,

It really depends upon what kind of authentication is configured under line vty for Login.

If you have AAA configured, then you need to use the Username/Password on the AAA Server.

Is there anyway, you could post any AAA and line vty configuration. Make sure that remove all sensitive (passwords,etc) information before you post the configuration.

I hope it helps.

Regards,

Arul

New Member

Re: SSH..

Thanks a lot. It helped. I used "transport input ssh" & "login local" on my vty lines.

92
Views
0
Helpful
3
Replies