im sure im doing something silly here, but there seem to be few options:
my management interface works fine as long as i dont attempt an ssl connect. i have clicked on the little icon and followed the instructions to install the cert (and have verified that it IS installed; on 3 machines yet) but whenever i attempt the ssl connect, i get the lovely server not found message (i.e 5.0, 5.5 and 6.0)
i have verified that https is enabled and have not monkeyed with any of the settings there.
I would suggest trying to Delete the SSL Certificate server, under: Administration | Certificate Management , then make sure the time is correct and then Regenerate it again under the same page. This helps most of the times and works like a charm.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...