I have managed to get working on my 877w Client-less and Thin Client SSL VPN modes but having trouble with the full tunnel setup. Externally I can launch the Anywhere client from the portal page (Tunnel Connection Start button). It connects and I get an IP address but I can't see any of the internal resources on the network (e.g. I can't ping/access the router or any of the other servers). Since this is my first Cisco router and I'm not very experienced with networking I would appreciate help on my configuration (attached).
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...