Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Stateful and lan Failover on same Interface

We have a Failover bundle (535's) with 4 GiG interfaces each. Are there any issues using same interface for both failover and stateful failover?

1 REPLY
Cisco Employee

Re: Stateful and lan Failover on same Interface

If your PIX is not "heavily loaded" then it's OK to use the same interface for both of these. The LAN interface is used for config replications and regular health checks. The stateful link will be much busier usually, but what you don't want to end up with is that the link is so saturated that the health checks can't get through and the units start failing over cause they think things are bad. The issue is exactly what is "heavily loaded", for which I really can't tell you an exact answer.

104
Views
0
Helpful
1
Replies