Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

stateful failover question...

I have two pix 515 firewalls. I'm ready to configure failover.

I believe my best option would be stateful failover.

I have a 100 mbps ethernet interface available on both firewalls to allow for the passing state data.

Do I still need to make use of that failover serial cable???

Thanks.

2 REPLIES
New Member

Re: stateful failover question...

Yes you will need to connect serial cable also, as it is the one communicating with primary and standby units.The dedicated interface will allow to communicate the states .

Refer the following link

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_61/config/failover.htm

Regards,

New Member

Re: stateful failover question...

Thank-you. This is my first attempt at this...

84
Views
0
Helpful
2
Replies
CreatePlease login to create content