Static Command problem

[anil.nair]

Hi!

When I enable a static command to give access to an inside host from outside my connection to the outside drops, My access-list is as follows

access-list 101 permit tcp any any

access-list 101 permit icmp any any

access-list 101 permit ip 10.101.3.0 255.255.255.0 66.153.9x.0 255.255.255.240

Static (inside,outside) 66.153.9x .x 10.101.1.54 netmask 255.255.255.255 0 0

access-group 101 in interface outside

Where could be the problem.. Can somebody help

Regards

Anair

[jmia]

Hi Anair,

From your list - are you just allowing one (1) outside host access to your inside network ? if so then the following document might be helpful to you:

http://www.cisco.com/warp/public/707/28.html#trust

Hope this helps... let me know how you get on....

Regards,

Jay