Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static Nat question

Hi Everybody,

I face the following issue:

I need to static nat a part of a range to a part of another range.

For the moment, i have the following config:

static (inside,dmz) 192.168.1.0 192.168.2.0 netmask 255.255.255.0 0 0

because, we need to have mapping one to one, to identify the PC using the IP address.

BUT, now, i need to extract one address from this range!!! Is there an option to exclude an address?

i need in final, the following config:

static (inside,dmz) 192.168.1.0 192.168.2.0 netmask 255.255.255.0 0 0 (with the address 192.168.1.10 extracted)

global (dmz) 1 192.168.1.10

nat (inside) 1 192.168.3.0 255.255.255.0 0 0

Thanks in advance,

Marc.

1 REPLY
Bronze

Re: Static Nat question

Yes this can be done using the NAT ID, the NAt will be executed based on this order

For example if you have

Nat(inside) 1 xxxx xxxx

Nat(inside) 2 yyyy yyyy

First Nat 1statement will be checked for a match, if there is not match then it will be checked with the next statement and so on.

161
Views
0
Helpful
1
Replies
CreatePlease to create content