Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static Virtual Tunnels Interfaces (SVTI)

Hi, I need some help in guiding me in how to apply SVTI for 60+ tunnels over a single interface. (i.e source and destination are the same for all tunnels s = 10.0.0.1 and dest = 10.0.0.2. When I try to create more than one tunnel, the first tunnel goes down.

1 REPLY

Re: Static Virtual Tunnels Interfaces (SVTI)

Karen,

Yep - you have hit the first show stopper with multiple tunnels using the same IP scheme!

I have 115 tunnels from my D/C's going to remote sites - no issues, as I have allocated specific IP address ranges.

My tunnels have specific /30 addresses out of a /24 range. I use loopback's for source & destination's for the tunnels - the loopbacks are part of their own /24 with 255.255.255.255 subnet masks.

To be honest if you have planned your IP subnet structure correctly - you should have no issues giving your 60+ tunnels unique ip addresses.

HTH.

564
Views
0
Helpful
1
Replies