When the logging settings (presumably the syslog settings) are too detailed (notifications or even higher), the FWSM suddenly reboots after 10-15 seconds. It only works, when almost all logging settings are set to warnings or lower.
Are there any special settings to be made, to prevent the FWSM to reboot on heavy (too detailed) logging?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...