I tried to get CLID Preauthentication work using Radius(Cisco ACS)with additional PPP Chap Authentication using ISDN and POTS service. got this work in IOS version 12.2.5 but needed 2 users configured on the Radius.
the target is to use the temporarly created CLID-user(outbound servive) by the AS5300 for "second" authentication(framed protocoll)using the ppp service and push to this CLID-user an exclusive IP-Address. how can i get around here?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...