Support for 3GE/2FE on a PIX 525

[phaddad]

Is this a supported HW configuration? It isn't listed

as such in the install manual. I'm guessing that the

2 built-in interfaces aren't listed in that table

in the install manual, just the interfaces that can

be added via the PCI slots.

Peter

[thamdani]

Hi,

Check the list of options for number of interfaces you can use on pix-525.It will depend on the License you have in pix.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/hig63/525.htm#wp1040963

Hope this helps.

Tanveer

[phaddad]

Actually your link points to the same table I

referenced in my earlier post. My interpretation

of this table is that it shows the possible

combinations of interfaces that can be installed

using the 3 PCI slots, and doesn't include the

2 built-in FE interfaces.

I tested this by installing 3GE PCI cards, and all

the interfaces (3GE + 2FE) are recognized by the OS,

so I'm assuming that this is a supported configuration.

thanks,

Peter