Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

switch port errors using spwr0 interface

I have 2 sensors at 2.5 (1) S3 that seeme to generate link up/down errors on the switch they are connected to. Does anyone know how to fix this? I think both sides are set to autosense. Should I hard code one side? What should the settings be?

Thanks,

Dan

3 REPLIES
Cisco Employee

Re: switch port errors using spwr0 interface

I recommend hard coding the switch side to 100MB Half-Duplex.

New Member

Re: switch port errors using spwr0 interface

Is Half-Duplex the only choice on the 4230 sensor's, or is this configurable to Full Duplex on the sensors?

Cisco Employee

Re: switch port errors using spwr0 interface

I always recommend hard setting network to network devices. 100mb full duplex on the switch port should work fine. You may need to reload the IDS depending what it already tried to autosense to.

107
Views
0
Helpful
3
Replies