I' have a problem with messages who're not logged in the syslog. My Pix firewall cluster doesn't log messages with syslog ID 104001 to 104004 when failing over from one node to another. When I activate console logging with the same log level, the messages are displayed in the console
Also, look at the syslog trap level in the pix config and make sure that your sys logger can accept and process messages of that level and lower. For instance, if your pix is set so that the trap log level is info, but your system logger is set to only accept messages of level error and higher, then the info message will not get processed.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...