Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

tacacs+ config problem.

Hi, I just started to setup an ACS 3.0 server from our lab network for testing. I must have miss something on the switch. When I try to console or telnet to the switch if would ask for username and password, but it gives me a authentication failed message. I need help on bypassing the "username and password" through the console port so I can look at the configuration of the switch. Thank you...RT

2 REPLIES
Bronze

Re: tacacs+ config problem.

The following URL on password recovery should answer your question -

http://www.cisco.com/warp/customer/474/index.shtml

New Member

Re: tacacs+ config problem.

Thank you, that help.

95
Views
0
Helpful
2
Replies
CreatePlease to create content