Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TACACS+ Problem on Catalyst 6000

Hi,

we have a problem with TACACS+ Command Authorization on a Catalyst 6000 Supervisor. Software is CatOS 6.1(2).

Authorization for the command "enable" doesn´t work.

After entering the command "enable" we get the message "Command authorization failed" although the TACACS+ daemon is configured to permit the enable-command.

Authorization for other commands works fine.

Why ?

Thanks

1 REPLY
Cisco Employee

Re: TACACS+ Problem on Catalyst 6000

You can use "set authorization commands" command or "set authorization exec" command to achieve this?

Following URL might help

http://www.cisco.com/warp/public/480/72.shtml

(Note: see Step C & Step D)

R/Yusuf

132
Views
0
Helpful
1
Replies