04-16-2003 07:35 AM - edited 02-20-2020 10:41 PM
I have added the line "telnet 0.0.0.0 0.0.0.0 outside" to my PIX 515e and I still cannot telnet to it from the outside. Do I also have to add an ACL entry for this? The permit IPSec command permits IPSec without having to add an ACL. Is the telnet command different?
Thanks,
Diego
04-16-2003 07:42 AM
04-16-2003 02:24 PM
The short, non-linked reply is "You cannot Telnet to the PIX from the outside, it is forbidden."
You CAN set up SSH (version 1) from the outside, but it's not recommended if it can be avoided. SSH ver 1 is still not too secure.
Good Luck
Scott
04-16-2003 02:28 PM
If you want to telnet to the outside interface of a pix, the only way
the pix software will allow you to do that is through an IPSec
connection.
As far as I have know, there is no other way to telnet to the outside interface.
04-16-2003 02:42 PM
I get the picture. I will try SSH. However, what then is "telnet 0.0.0.0 0.0.0.0 outside" good for? Do I need this with SSL?
Diego
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: