terminate clients on 3640, then ride L2L to behind pix
Client has 3640 at their mail co-lo. They have a pix515 at the office. I now know that you can't terminate their clients to the pix and let them hop into the L2L to get down to their mail. I am hearing that I can do the reverse. Terminate the clients on the 3640, setup a L2L between the 3640 and the pix, let clients ride the L2L after connecting to the 3640. Is this right?
I have looked high and low on Cisco, so if anyone says yes, could you point me to the right place or show me a config!
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...