All the configurations that i have read to Cisco Site is to terminate the ipsec tunnel in the HSRP address of the outside interface of the router.My problem is that i have serial interface for outside interface i tried to terminate the ipsec tunnle in the HSRP address of the inside Fast ethernet interface but it doesn't work.
Are you terminating the tunnel on a Router or a PIX ? If a router you can terminate on a HSRP address but will require specific IOS .Mail me at firstname.lastname@example.org and I'll find out the IOS you require.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...