I changed the external address of my 515 last night as part of an ISP change. Now my remote 501 can't establish the tunnel that was previously there. I changed the "isakmp key **********addresess x.x.x.x netmask 255.255.255.255" and " crypto map transam # set peer x.x.x.x" commands to match the new ip address but still doesn't work. Any idea what I'm missing. Also, what commands can I use to check that there's traffic thru my tunnel. Thanks in advance.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...