Traffic stops after adding new GIG cards in a 535 ver 6.3.3
Are we missing something?
When adding 2 additional GIG cards in a pix 535 running ver 6.3.3 into slots 0 & 1, we noticed that all traffic thru the pix had stopped. In other words no traffic was traversing the pix. On the internal NIC we had recieve traffic but no transmit (internal) and external we had recieve traffic but no transmit (to internet) traffic. I have included our sh version of the pix. Is there a bug of something we may have missed that may be causing this indication? The licensing looks to be in order.
Thanks, Mike G.
pix# sh ver
Cisco PIX Firewall Version 6.3(3)
Cisco PIX Device Manager Version 3.0(1)
Compiled on Wed 13-Aug-03 13:55 by morlee
fwlucpix01 up 7 days 9 hours
Hardware: PIX-535, 1024 MB RAM, CPU Pentium III 1000 MHz
Flash i28F640J5 @ 0x300, 16MB
BIOS Flash DA28F320J5 @ 0xfffd8000, 128KB
0: gb-ethernet0: address is 000e.0c34.562a, irq 12
1: gb-ethernet1: address is 000e.0c34.5f91, irq 255
Re: Traffic stops after adding new GIG cards in a 535 ver 6.3.3
I have not worked with the 535, but it could be that when you added the Gigabit interfaces, since they became Interfaces 0 and 1, the configuration for the existing Interfaces may have either been deleted, or moved onto the new interfaces. It would help if you posted your (cleaned) config to see if this is what happened, or if there may be something else going on.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...