Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trouble with site-to-site VPN

Hello

I cannot get 2 newly configured devices to establish a site-to-site VPN. They are an ASA running v7 (212.240.128.45) and a Pix 501 running v6.3 (10.71.135.4). Both devices are providing internet access fine. The 10 address on the Pix is translated to 193.238.166.50 by Siemens which was confirmed by logging onto GRC.com to check my IP. I suspect my problems are being caused by the 10 translation but I would be grateful if someone could check my configs (I'm a relative newcomer to firewall config) and confirm if they're OK. I've also attached a sample of the syslog from the ASA. The 193.238.166.51 address it refers to is the WAN interface of a Sonicwall firewall plugged into the same switch as the Pix. Any help would be greatly appreciated.

Thanks, Rex

1 REPLY
Cisco Employee

Re: Trouble with site-to-site VPN

Can not see any config attached.

-Kanishka

88
Views
0
Helpful
1
Replies
CreatePlease login to create content