I tried to configure the PIX for remote access using certificate. According to the document, I need tunnel-group DefaultRAGroup, and it should be pre-configured. However, I don't see it on my configuration. Does it mean that I need to configure this DefaultRAGroup on the PIX manually?
Hi .. you don't need to create these groups. They are created by default and even though you can modify it you can't delete them. these are the defaults parameters contained on the default remote access group. If you need to modify any parameters enter the group mode by
tunnel-group tunnel_group_name general-attributes
tunnel-group tunnel_group_name ipsec-attributes
"The contents of the default remote-access tunnel group are as follows:
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...