Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Turning off blocking

I am unable to turn off blocking at our border router. I have removed the router and information from the "blocking devices," but every time we get a high alert, it replaces our acl again. What is the resolution for this?

4 REPLIES
New Member

Re: Turning off blocking

My current versions are:

4230 sensor 3.0(s4)

cspm 3.0i

Cisco Employee

Re: Turning off blocking

Use CSPM to disable managed on the Sensor.

New Member

Re: Turning off blocking

Where do I go within CSPM to disable managed? It seems that I've looked everywhere.

Cisco Employee

Re: Turning off blocking

Managed is configured to run when configuration entried exist in the Blocking Tab.

This logic is built into the CSPM product so there is not a check box or anything to turn managed on or off.

So to ensure managed does not run:

Click on the Blocking Tab and remove all entries from the following tabs:

Never Block Addresses (Not positive that these have to be removed, but you might want to just in case)

Blocking Devices (Remove these, this tells the sensor which routers to telnet to)

Master Blocking Sensor (Remove these entries as well just to be sure managed is not running.)

107
Views
0
Helpful
4
Replies
CreatePlease login to create content