Two different ISP t-1's and one PIX

[wvaux]

Is there a way to configure the PIX to load share across these two T-1's? I have looked at the failover by having a second PIX but is there another way? I want to be able to utilize both at the same time to decrease the load on the primary.

[bducharm]

Hi there. Currently, the PIX itself does not load balance. You can provide load balancing using the CSS products. Also, in a failover configuration, there is no load balancing achieved. There is a possibility of having an "active-active" configuration sometime down the road, but not yet.

[wvaux]

Thanks, i thought this would be the case.

[kwon47]

Just use a router outside of the PIX to load-balance on these links.

Tony