Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Two different ISP t-1's and one PIX

Is there a way to configure the PIX to load share across these two T-1's? I have looked at the failover by having a second PIX but is there another way? I want to be able to utilize both at the same time to decrease the load on the primary.

3 REPLIES
New Member

Re: Two different ISP t-1's and one PIX

Hi there. Currently, the PIX itself does not load balance. You can provide load balancing using the CSS products. Also, in a failover configuration, there is no load balancing achieved. There is a possibility of having an "active-active" configuration sometime down the road, but not yet.

New Member

Re: Two different ISP t-1's and one PIX

Thanks, i thought this would be the case.

New Member

Re: Two different ISP t-1's and one PIX

Just use a router outside of the PIX to load-balance on these links.

Tony

113
Views
0
Helpful
3
Replies
CreatePlease to create content