Re: two inside interfaces connect to router with ospf
You can use OSPF to do Equal Cost Multi Path load balancing across up to three equal cost routes (but not static routes - they must be learned via OSPF). However, you can't have multiple interfaces on the same subnet. You also can't have multiple Inside (i.e. Security100) interfaces. If you need interface redundancy you'll have to use failover with another 535.
RADIUS and Symantec VIP.
I will use screenshots of ASDM, and at the end I will add the required CLI commands. the diagram below show a diagram of the steps the FW goes through when using 2FA authentication:
As you can see in Fig. 1&nbs...
Unable to get signature update from cisco.com
1. Make sure the router can get name resolution. Configure the router with a proper DNS name server.
ISR4451#utd threat-inspection signature update server cisco username xxxxx password yyyyy