Opening UDP is similar to TCP. Depending on your requirement, you need to configure address translation or no translation (nat0) and ACL, then bind it to the interface where UDP traffic will go out, e.g if DMZ (sec50) host need to access Inside (sec100) server, create the ACLs and bind it on the DMZ interface (use "access-group xxx in interface " command).
The difference is that UDP is connectionless, so if you issue "sh conn" command, you'll not see the connection details like TCP. Simple example is when client accessing DNS Server via port 53 (command: sh conn | i 53)
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...