01-25-2008 08:58 AM - edited 02-20-2020 09:40 PM
I've created an ACL to allow FTP 20 & 21 and ping in a L2L tunnel. When I use ASDM and click on the cryto map to edit the traffic selection area, I can find pre-defined services, but not any ACLs I've created. How to I apply an ACL to a crypto map within ASDM?
01-31-2008 11:35 AM
If you created the ACL using CLI and in this time the ASDM was running, you will have to re-sync the ASDM with current configuration of the device. The reason you are not able to see the ACL is because ASDM is not aware of the config changes.
01-31-2008 12:04 PM
I created the ACL in ASDM, but it doesn't show up in the crypto map, traffic selection config screen. It does show up in the ACL area under the firewall config though, but that isn't accessible within the VPN config area.
Any other ideas?
01-31-2008 12:38 PM
If it is displaying in the config -> firewall -> access rules area then it is probably assigned to an interface, which it shouldn't be. Make sure it's not listed in a show run access-group.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide