Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
mx
Community Member

unable to get to internet

Hi all. I had to create a vpn profile today on the ASA that does NOT allow split tunnel. Everything seemed to go well, but I cant get to the internet once I connect. Login is OK etc, I get the right address but it ends there. I know I forgot a stupid line somewhere I just cant figure it out.

This is the tunnel group in question (config attached (I hope))

tunnel-group rtptacvpn type remote-access

tunnel-group rtptacvpn general-attributes

address-pool newpool

authentication-server-group ehr

default-group-policy newpolicy

tunnel-group rtptacvpn ipsec-attributes

pre-shared-key *

4 REPLIES

Re: unable to get to internet

Did you specify a DNS server? Also, are you able to ping an external IP address?

Please rate useful posts.
mx
Community Member

Re: unable to get to internet

Thank you for the reply, let me verify if I can ping by address...

mx
Community Member

Re: unable to get to internet

as an update, I cannot ping anything by address. I did add dns-server value 10.10.10.43 10.10.10.41 to the group policy but still no joy.

Also, I cant ping anything on the inside either. :(

mx
Community Member

Re: unable to get to internet

OK apparently I didnt attach first time, try this.

134
Views
0
Helpful
4
Replies
CreatePlease to create content