Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to NAT out

Out/In

DSL (DHCP for vlan2) 192.168.1.1

FW ports 0,6,7 are on vlan2

vlan2 is 192.168.1.2

INSIDE: 10.25.0.x (vlan1)

ACL is set to allow all 10.25.0.x traffic out.

NAT is configured to allow all 10.25.0.0 to 192.168.1.1

Inside is only able to ping the 10. traffic, unable to ping out even with icmp active.

2 REPLIES
New Member

Re: Unable to NAT out

If u want to access the internet, then u have to do these config to add--

nat (inside) 1 0 0

global (outside) 1 interface

after issuing these commands, u will be able to go to the internet.

New Member

Re: Unable to NAT out

The other problem was not being able to ping anything on the inside net. I placed an acl stating: source-192.168.1.0 destination-10.25.0.2 to allow all icmp.

103
Views
0
Helpful
2
Replies