Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unable to sync configuration from Active

Dear All,

My secondary PIX started to reboot automatically and it is giving below messages.

My pix is 515E with 8.0 OS

Can some body tell what can be the problem

========================= NOTICE =========================

This platform is licensed to run in

failover secondary mode only

==========================================================

Detected an Active mate

Unable to sync configuration from Active

.

========================= NOTICE =========================

This platform is licensed to run in

failover secondary mode only

==========================================================

Detected an Active mate

Unable to sync configuration from Active

.

1 REPLY
Silver

Re: Unable to sync configuration from Active

Check if the failover cable is connected properly and not damaged. If this does not helps configure failover on some other interface of the device.

1030
Views
0
Helpful
1
Replies