Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

unnumbered interface and network-extension mode

I've configured EasyVPN with Dynamic Virtual interfaces and its seems everything works fine if I'm using client mode in EasyVPN client. When I changing mode to network-extension it doesn't honor ip unnumbered configuration on my virtual-template and using always IP from my WAN interface.

See in attachment my corresponding configuration on client.

This doesn't affect PCs behind router but affect router responses comes from WAN even if I request from VPN.

1 REPLY
Silver

Re: unnumbered interface and network-extension mode

Better solution is to check that the (sub)interface is not in use before provisioning.

248
Views
0
Helpful
1
Replies