Are you able to stop the recovery from continuously running? Use "hw-module module 1 recover stop" to end it. Then try to reset it again (hw-module module 1 reset).
If the module become unresponsive due to too long running in recover mode, big chances you need to reset the ASA. But try to reset/shut it down via ASA CLI first before decide to shutdown/powerup the whole box. This may be inevitable. During shutdown, remove the module, and power-up the ASA. Insert the module once the ASA is properly running, and check the status/mode again.
Start the boot recovery process again, recover configure if necessary. If you need to stop it, issue "hw-module module 1 recover stop" within 45sec after the recover boot/configure started.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...