08-20-2003 12:12 PM - edited 03-09-2019 04:29 AM
Under 3.x on the IDS sensor, I could just updated the signature set on the MC and it would then update the sensor. With 4.X on my sensor, I seem to have problems.. I finally wind up updating my sensor signatures manually, then have to delete it from MC and re-discover it in order for MC to recognize the new sensor signature set. Am I doing something wrong or missing step here?
Thanks..
08-20-2003 02:19 PM
Hi,
Various people have had problems updating signatures if you look around the forum.
I have found that if you are using the IDSM-2, you need to ensure you have an updated app and maintenance partition.
For appliance sensors and in general, first apply the update only to IDS-MC and don't select sensors. Then re-do the process after MC is updated and select the sensors.
I also found I had to do the same things as you if I tried to update the MC and select the sensors in one pass.
Is this a know issue (Cisco?)
08-20-2003 05:53 PM
Thanks... sat down and did the update to the .50 sigs this evening and it worked fine out of the box...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide