Upgrading PIX from 6.3(5) to 7.0(4)

[jhaggett]

I'm upgrading a PIX from 6.3(5) to 7.0 with Ezvpn. The config moves over fine, however, none of my remote VPN clients can connect. I'm receiving the error:

"Removing peer from peer table failed, no match!

Error: Unable to remove PeerTblEntry"

I had this issue going straight from 6.3 to 7.2 and TAC recommended doing an incremental upgrade 6.3 - 7.0 - 7.1. I tried the incremental and obviously i'm still experiencing this error. Just curious if anyone here has experienced this.

The main pix is a 515E Unrestricted and the clients are all PIX 501's.

Thanks!

[m.sir]

Could you try following command on 515

isakmp identity address

M.

Hope that helps rate if it does

[jhaggett]

Actually, I called TAC back and the fix was to type "nem enable" for each remote site under the group-poliy attributes. Thx for your response though.

[khaled.benhaj]

Hi,

I have the same problem.

Could you please give a configuartion example with the command "nem enable" that you specify.

Thank you in advance