URL Redirection using eou on Catalyat 3750 and 3560
I would like to redirect web traffic to/from a particular L2 switch port to a dedicated URL. I can successfully implement this on a 3750 switch with IOS version 12.2(44)SE. However, when I apply the same configuration to our 3560 (with IOS 12.2(25)SE2 and 12.2(44)SE, this cannot be done successfully. I have made a traffic capture and found that 3750 intercept the WEB request from the end user and then pretend the WEB server to reply a WEB move/redirect message to the client and hence user can be rediretecd to another URL. However, for 3560 it simply send a TCP reset to the client. Any recommendation for this problem?
Re: URL Redirection using eou on Catalyat 3750 and 3560
This problem has been fixed when I enable the ip http server on the switch. If "ip http server" global configuration is not enabled, the switch will send out http reset to the clinet only during the URL redirection process. Once ip http server is enabled, URL redirection will be sent out to the client instead.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...