Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using ASDM for failover setup - GTP/GRPS Fails?

I'm trying to setup 2 ASA5520 in active/passive failover using the ASDM wizard, but during the tests it reports: License combatibility test for GTP/GPRS failed (Disabled, Disabled)

Suggestions?

4 REPLIES
New Member

Re: Using ASDM for failover setup - GTP/GRPS Fails?

Can you do a show version command and post the result please.

New Member

Re: Using ASDM for failover setup - GTP/GRPS Fails?

CiscoASA(config)# sh ver

Cisco Adaptive Security Appliance Software Version 7.2(1)

Device Manager Version 5.2(1)

Compiled on Wed 31-May-06 14:45 by root

System image file is "disk0:/asa721-k8.bin"

Config file at boot was "startup-config"

CiscoASA up 1 day 5 hours

Hardware: ASA5520, 512 MB RAM, CPU Pentium 4 Celeron 2000 MHz

Internal ATA Compact Flash, 64MB

BIOS Flash M50FW080 @ 0xffe00000, 1024KB

Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x

Boot microcode : ☻CNlite-MC-Boot-Cisco-1.2

SSL/IKE microcode: ♥CNlite-MC-IPSEC-Admin-3.03

IPSec microcode : ☺CNlite-MC-IPSECm-MAIN-2.04

0: Ext: GigabitEthernet0/0 : address is 0018.1900.1110, irq 9

1: Ext: GigabitEthernet0/1 : address is 0018.1900.1111, irq 9

2: Ext: GigabitEthernet0/2 : address is 0018.1900.1112, irq 9

3: Ext: GigabitEthernet0/3 : address is 0018.1900.1113, irq 9

4: Ext: Management0/0 : address is 0018.1900.1114, irq 11

5: Int: Not licensed : irq 11

6: Int: Not licensed : irq 5

Licensed features for this platform:

Maximum Physical Interfaces : Unlimited

Maximum VLANs : 100

Inside Hosts : Unlimited

Failover : Active/Active

VPN-DES : Enabled

VPN-3DES-AES : Enabled

Security Contexts : 2

GTP/GPRS : Disabled

VPN Peers : 750

WebVPN Peers : 2

This platform has an ASA 5520 VPN Plus license.

Re: Using ASDM for failover setup - GTP/GRPS Fails?

Hi .. Can you post a show ver from both ASAs

New Member

Re: Using ASDM for failover setup - GTP/GRPS Fails?

I have the same problem, with the same version. I have configured failover manually.

327
Views
0
Helpful
4
Replies
CreatePlease to create content