Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Using AUS with PIX MC in VMS 2.2

Hello,

My PIX does not appear in AUS after having imported it in PIX MC, generated the config for a deployment with AUS (menu Configuration > MC Setting > Deployment).

Thank you

Patrice

2 REPLIES
New Member

Re: Using AUS with PIX MC in VMS 2.2

You must perform a deployment now. This will deploy to AUS and the device will show up there.

You will also need to bootstrap the device itself to start using AUS.

One way to do this is to perform a direct deployment from Firewall MC (aka PIX MC). Change the deployment setting to direct, select Save and Deploy, and then select Deploy Now.

Once the device is contacting AUS OK, then you can change the deployment setting back to AUS. Future deployments will then go to AUS.

New Member

Re: Using AUS with PIX MC in VMS 2.2

Hi,

I thank you for this answer, it works now.

94
Views
0
Helpful
2
Replies
CreatePlease to create content