we currently have an ethernet link between two sites and a tunnel between the sites as well. However, we also have a route inside command on the firewall (506e) to send traffic directed to the other site to the router where the ethernet link terminated. we have it because the pix uses ACS and the server is located at the other site. The router also knows about the subnets on the other side through eigrp.
Now I was thinking about adding some static routes on the 506e as such:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...