Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLAN Configuration using a Layer 3 Services Module

I'm trying to configure inter-VLAN routing on a Cat 4006. I have configured 2 VLANs and I have a PC in each. I can't ping across VLANs for some reason. Any suggestions?

3 REPLIES

Re: VLAN Configuration using a Layer 3 Services Module

The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: VLAN Configuration using a Layer 3 Services Module

What does show IP route say?

New Member

Re: VLAN Configuration using a Layer 3 Services Module

1st thing 1st, have you purchased the Enhanced IP License for the L3 module?

104
Views
0
Helpful
3
Replies