Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLAN help

I ahve to make 4 VLANS currently i have 2x 2960 switches and 1 router , since i m new to cisco i want to know how to terminate and implement this .

2 REPLIES

Re: VLAN help

Hi Imran, I helped someone a while back with similar requirements, please see attached thread. In your case you have 2960 switches which are pure layer 2 switches so you will have to do the intervlan routing through your router. Use dot1q trunk from router to switch, but if your router have available FE ports I would recommend have dedicated FE port for each of your 4 vlans other wise just use trunking , I believe you could stackwise the 2960s and from there connecto to router.. if you can build a script and post it for revision we will be more than happy to assist you.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Archive&topic=Network%20Infrastructure&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cbe6d65

Rgds

Jorge

And remember to rate any helpful posts

New Member

Re: VLAN help

Thanks.

But the issue is i have only 2 ports on my 1811 and I am already using 1 so can i still do VLAN thing and inter vlan using that single port. Plus i have 1 issu that is i have 2 2960 if i will stack both and than user 2 trunk port on each router than how am i going to connect those trunk ports on the router

106
Views
0
Helpful
2
Replies