Hi, I would like to know if it's possible configure signatures on a IDS directly with IDS MC or i must use IDS device Manager. If i have more than 50 IDS and i want to change a global signature i must configure each sigle IDS and it's take long time.I see that in IDS MC there is the possibility to add a lot of IDS on the same group but i can't do anything else.
In the current release of the IDS MC, you cannot configure signatures at the group level. This is planned for a future release. However, you can configure the signatures for 1 sensor and then use the Copy wizard to copy the settings to multiple sensors. The Copy wizard is located under the Configuration tab.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...